Decals application

Step 1.

Cut off decal from sheet. Remove all white outside.

Step 2.

Dip the decal in very warm to almost hot water for about 30 seconds.

Step 3.
Take out decal from water. Do not move with transfer foil. Hold the backing sheet edge and gently slide decal onto the helmet.

Step 4.
Gently move the decal into position by wetting decal with finger. Do not use nails because the decal is vulnerable at this stage.

Step 5.
Press decal gently down with a soft cloth until excess water and air bubbles are gone. Since this step, do not interfere decal at least 2-3 hours.

Step 6.
Leave the helmet dry out on daily light and fresh air for 3-4 hours. Continue with decal conservation process.


Decals conservation

Fix the decal with spray lacquer. Use the lacquer for watertransfer decals (is made for plastic model kits). Do not use hair spray.